Futaba14SG1   Futaba 14SG Combo With R7008SB (Mode 1) 

Description

- Channels: 12 proportional, 2 switched
- Compatible with FASSTest, FASST and S-FHSS protocols
- FASSTest telemetry – compatible with Futaba telemetry sensors (sold separately)
- Free user-updatable software
- 30-model memory
- 10-character user naming
- 10-character model naming
- Airplane, helicopter and glider programming
- Large, 1.75” x 3” backlit LCD screen with 128 x 64 resolution
- SensorTouch™ programming
- SD Card compatibility for external model memory and software updates (SD: 32MB-2GB; SDHC 4GB-32GB)
- Left and right assignable slider switches
- Two assignable rotary knobs
- Six assignable three-position switches
- One assignable momentary two-position switch
- One assignable two-position switch
- Comfortable rubber grips on the sides and back
- Wide top switch spacing
- Adjustable stick tension
- Dual ball bearing gimbals
- 4 vibration warning types
- Home/Exit; User Menu/Servo Monitor buttons
- Audio earphone jack (for telemetry alarms)
- 6V 1800mAh NiMH battery pack
- User stick calibration
- Trainer system
- Servo speed adjust
- 5 programmable mixes
- V-tail, Ailvator, winglet, motor mixing
- Trim mix
- Logic switch (condition switch only)
- Internal programmer for S.Bus servos
- User menu
- Servo monitor (neutral and moving tests)
- 2 count up/countdown timers
- Integral timer
- Model timer
- Quick model select

Specific Features (Heli)

- 6 swash plate types
- Pitch/throttle curves (5-point)
- Throttle hold
- Swash mix
- Throttle mix
- Pitch to rudder mixing
- Fuel mixture
- Gyro (Flybarless support)
- Governor (700-3500 rpm)
- Hover pitch
- Hover throttle
- High/low pitch
- Swash AFR
- Swash setting (mixing rate, linkage compensation, speed compensation)
- Swash ring (electronic)
- Throttle cut